F92 appears; AutoOpen drying function may fail and door may not open at end of cycle.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Faulty AutoOpen actuator control circuit, Misconfigured program parameters, Control board output failure

Safety: Disconnect power before accessing the control panel.

Check settings: Verify in the user menu that AutoOpen is enabled.
Inspect actuator wiring: Ensure the AutoOpen actuator connector is properly seated at both the actuator and control board.
Test operation: Run a service or test program (if available) to trigger AutoOpen.
Replace control or actuator: If wiring and actuator are good, the control board may require replacement.

Hard 4/5

AutoOpen Door Actuator or Control Board

Check Price on Amazon

We may earn a commission from links on this page.