F1
Monogram
Flood Protection Activated
Dishwasher displays F1; may indicate a flood or leak condition with drain pump running.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Water in base pan of Monogram dishwasher, Leaking hose or pump seal, Cracked sump, Excessive suds causing overflow
How to Fix / Troubleshooting
Safety: Disconnect power and shut off water supply immediately.
- Remove toe kick and inspect base: Look for water in the base pan. If present, dry completely with towels or a wet/dry vacuum.
- Identify leak source: With power briefly restored, run a short fill and observe hoses, sump, and pump for drips. Then disconnect power again.
- Check door seal and spray arm: Ensure the door gasket is intact and spray arms are not cracked or spraying directly at the door seams.
- Eliminate oversudsing: If non-dishwasher detergent was used, run multiple rinse cycles (after drying base) with no detergent to clear suds.
Repair or replace any leaking components before returning the dishwasher to service. Do not bypass the flood protection system.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements