Mora
Program Interruption / Overheat or Control Glitch
Dishwasher stops mid-cycle without any error code; lights may remain on but no activity.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Temporary control board lockup, Overheating protection triggered, Faulty door switch, Power supply fluctuation
How to Fix / Troubleshooting
Safety first: Turn off the dishwasher at the mains before resetting.
- Reset appliance: Turn off the dishwasher using the power button, then unplug it for at least 5 minutes to reset the control board.
- Check door latch: Ensure the door is fully closed and the latch engages properly during operation.
- Ventilation: Make sure the dishwasher has adequate ventilation around it and is not overheating due to tight enclosure.
- Run test cycle: After resetting, run a short program and monitor. If the issue repeats at the same point, a component (heater, pump, or control board) may be failing and should be diagnosed by a technician.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements