Dishwasher displays E24; water remains in the tub and the machine may not start a new cycle.

Safety first: Unplug the dishwasher before disconnecting the drain hose.

• Inspect hose routing: Check behind the dishwasher for kinks, sharp bends, or crushed sections of the drain hose.
• Detach from sink trap: Place a bucket under the sink trap connection, remove the hose, and check for blockages in both the hose end and the trap spigot.
• Flush the hose: Run hot water through the hose to clear grease or sludge. Replace the hose if it is damaged or heavily clogged.
• Verify installation height: Ensure the drain hose is installed at the height specified in the Mora installation manual to prevent siphoning or backflow.
• Reassemble and test: Reconnect the hose, restore power, and run a drain cycle to confirm that E24 is resolved.