Dishwasher shows E7 and may stop shortly after starting; sometimes associated with incorrect water level readings.

Safety first: Disconnect power and close the water tap before removing the inlet hose or side panels.

• Check inlet filters and hose: Remove and clean the mesh filters at the tap and at the dishwasher inlet. Debris can jam the flow meter rotor.
• Access the flow meter: On many Mora models, the flow meter is integrated into the water inlet assembly or side water distribution chamber. Remove the side panel to locate it.
• Inspect and clean: Detach the flow meter housing if possible and check that the internal rotor spins freely. Rinse out any grit or scale.
• Check wiring: Ensure the small connector from the flow meter to the main harness is secure and not corroded.
• Test operation: Reassemble, restore power and water, and run a short cycle. If E7 persists, the flow meter module likely needs replacement.