E12
Teka
Drying Fan / Condenser System Fault
Dishwasher shows E12; may be associated with drying problems or fan operation.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed drying fan motor, Blocked air duct or condenser channel, Loose fan wiring, Faulty control board fan driver
How to Fix / Troubleshooting
Safety first: Unplug the dishwasher before removing side or top panels.
- Access fan assembly: On Teka dishwashers with active drying, the fan is usually located in the top or side panel connected to an air duct.
- Check for obstructions: Inspect the air duct and condenser channel for lint, plastic film, or other obstructions. Clean thoroughly.
- Test fan: With the fan disconnected, measure the motor coil resistance. An open circuit indicates a failed motor. Also check that the fan blades spin freely by hand.
- Inspect wiring: Ensure the fan connector is secure and wires are intact.
- Replace fan: If the motor is defective or seized, replace the drying fan assembly.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Drying Fan Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements