Dishwasher shows E7 and may not circulate water; spray arms do not spin and dishes remain dirty.

Safety first: Turn off power at the breaker and shut off water. Water inside may be hot.

Step-by-step checks:

• Listen for pump operation: Start a cycle and listen. If you hear only filling and then silence or humming without water spraying, the circulation pump may be stuck or failed.
• Check for obstructions: Remove lower spray arm and filters. Inspect the sump for broken glass, bones, or other debris that could jam the impeller.
• Access pump: Tilt or pull the dishwasher out and access the bottom. Locate the circulation pump assembly and check for leaks or burn marks.
• Wiring inspection: Ensure the pump connector is fully seated and wiring is intact.
• Advanced: With power disconnected, a technician can test pump resistance and spin the impeller by hand. If stiff or open-circuit, replace the pump.

Warning: The pump area may contain sharp debris; wear cut-resistant gloves.