F2
V-ZUG
Door Not Recognized / Safety Interlock Fault
Dishwasher displays F2 and may not respond to start commands.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Door switch not closing, Misaligned door latch, Broken latch mechanism, Wiring fault in door harness
How to Fix / Troubleshooting
Safety first: Turn off power before adjusting the door hardware.
- Check door closure: Ensure the door closes fully and that no dishes or racks are obstructing it.
- Inspect latch and strike: Verify that the latch engages the cabinet strike properly. Tighten any loose screws and adjust alignment if necessary.
- Test with gentle pressure: With power on, close the door and apply gentle pressure at the top center. If the machine starts only when pressed, the latch or switch is misaligned or worn.
- Repair: Replacing the door lock or adjusting the latch mechanism may be required. This is usually a moderate repair; if unsure, contact a technician.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Lock / Latch Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements