Winterhalter Base Tray Drainage / Minor Leak

Machine leaves standing water in the base tray after normal shutdown, but still operates.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Small internal leak into base tray, Blocked base tray drain (if fitted), Condensation accumulation, Loose hose clamp

Safety first: Disconnect power and close water supply before removing panels.

Inspect base tray: Remove the kick panel and check for standing water. Mop up and dry thoroughly.
Check for slow leaks: Run a short cycle while observing hoses and pumps for drips.
Tighten clamps: Secure any loose hose clamps found.
Monitor: If water reappears, a technician should locate and repair the leak source before it triggers a safety shutdown.

Hard 4/5

Hose Clamp Set

Check Price on Amazon

We may earn a commission from links on this page.