E9
Amana
Internal Control Error
Dryer displays E9 and may not start or may shut off quickly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control firmware, Internal control failure, Voltage surge damage, Overheated control board
How to Fix / Troubleshooting
Safety first: Unplug the dryer before any inspection.
- Power reset: Leave the dryer unplugged for at least 5 minutes to allow the control to fully discharge, then plug back in and test.
- Check installation: Ensure the dryer is in a well-ventilated area and that the control board area is not blocked or excessively hot.
- Inspect control board: Access the main control and look for burn marks, bulging components, or corrosion.
If E9 returns after a reset and no external issues are found, the main control board is likely defective and should be replaced.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements