F6
Amana Communication Error Between Main Control and User Interface

Dryer shows F6 and may not respond properly; display may be blank or show erratic characters.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Loose or damaged communication harness, Corroded console ribbon cable, Failed main control board, Failed user interface board

How to Fix / Troubleshooting

Safety first: Unplug the dryer before accessing the console or control board.

  • Inspect harness connections: Remove the console or top panel to access the main control and UI board. Reseat all multi-pin connectors and ribbon cables between them.
  • Check for damage: Look for pinched wires, corrosion, or burn marks on connectors and boards.
  • Power reset: After reseating connectors, leave the dryer unplugged for 5 minutes, then restore power and test.

If F6 returns, one of the boards is likely defective. Replacing the main control is common, but on some models the UI board may be at fault; follow Amana’s service diagnostics or consult a technician.

Advertisements

Repair Difficulty

Hard 4/5

Required Part

Main Control Board
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements