E19
Amica
Internal Memory / EEPROM Fault
Dryer shows E19 and may not start or may stop unexpectedly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware, Failed EEPROM chip on PCB, Power surge damage, Incomplete software update (if applicable)
How to Fix / Troubleshooting
Safety first: Unplug the dryer before any disassembly.
- Power reset: Leave the dryer unplugged for at least 10 minutes, then reconnect and try again. This can clear transient memory errors.
- Check for signs of surge damage: Inspect the main PCB for burned components or discoloration, especially near the power supply section.
- Surge protection: If E19 occurred after a storm or power cut, consider using a surge-protected outlet in the future.
- PCB replacement: Persistent E19 usually indicates a defective control board. Replace the main PCB with a pre-programmed Amica spare part. This task is best performed by a qualified technician to ensure correct configuration.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements