F14
Ariston
Dryer Heater Relay / Element Fault (Washer-Dryer Combo)
On washer‑dryer combos: drying heater not operating, F14 displayed
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open dryer heater element, Failed heater relay on control board, Burnt heater wiring connector
How to Fix / Troubleshooting
Safety first: Disconnect mains power before accessing the rear of the combo unit.
- Inspect heater assembly: Locate the dryer heater on the combo’s air duct. Check for burnt smell, discoloration, or broken terminals.
- Check wiring: Ensure all heater wires are secure and not overheated. Replace any burnt connectors.
- Replace heater: If the element is open circuit, replace the dryer heater assembly with the correct Ariston part.
- Control board check: If the heater is good but F14 persists, the heater relay or control board may be faulty and should be tested by a technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Dryer Heater Element (Combo Unit)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements