E06
Candy Control Board / EEPROM Communication Fault

Dryer stops or will not start; E06 displayed, sometimes after a power surge or during moisture sensing phase.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Corrupted control board firmware, Loose connector between display PCB and main PCB, Power surge damage to main control board, Oxidized PCB connectors

How to Fix / Troubleshooting

Safety first: Unplug the dryer before removing any panels.

Soft reset:

  • Disconnect power for 5–10 minutes to allow the electronics to discharge.
  • Reconnect and attempt to start a basic timed cycle.

Hardware checks:

  • Remove the top cover and inspect the main PCB and display PCB connections. Reseat all multi-pin connectors firmly.
  • Look for signs of burning, cracked solder joints, or moisture on the control board.

Next steps: If E06 returns after reseating connectors and power-cycling, the main control board may need repair or replacement. Firmware reprogramming typically requires Candy service tools, so contact an authorized technician.

Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Main Control Board
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements