Dryer shows E19 and may not complete cycles; can be linked to internal memory or configuration errors.

Safety first: Disconnect the dryer from mains before accessing internal electronics.

• Power reset: Unplug the dryer for at least 10 minutes to allow capacitors to discharge and the control to fully reset. Reconnect and test.
• Check supply stability: Ensure the dryer is connected directly to a stable mains outlet, not via long extension leads or unstable power sources.
• Factory reset (if available): Some models allow a factory reset via a button sequence (consult service documentation). Perform this if accessible.
• PCB replacement: If E19 persists, the EEPROM or firmware on the main PCB is likely corrupted. The usual remedy is replacement of the main control PCB with a correctly programmed Caple part, which should be done by an authorised service technician.