E17
Essentials
Thermal Cut-Out Tripped
Dryer displays E17 and may stop with a beeping alarm; often related to overheating.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked lint filter or exhaust duct, Failed or weak cooling fan, Ambient temperature too high, Repeated overheat causing thermal cut-out to open
How to Fix / Troubleshooting
Safety first: Unplug the dryer and allow it to cool completely. Do not reset or replace thermal devices without correcting the cause of overheating.
- Clean airflow path: Thoroughly clean the lint filter, exhaust hose, and wall vent. Remove any kinks or crushing in the hose.
- Check cooling fan (if fitted): Some Essentials dryers have an internal cabinet cooling fan. Ensure it spins freely and runs during operation. Replace if seized or not running.
- Inspect thermal cut-out: Access the heater housing and locate the thermal cut-out. Test for continuity. If open, replace it with the correct rated part and ensure airflow is restored.
- Room conditions: Ensure the dryer is not installed in a confined, unventilated space or near a heat source, as this can contribute to overheating.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Thermal Cut-Out
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements