Dryer displays E11; on condenser models, drying performance is poor and the unit may stop prematurely.

Safety first: Unplug the dryer. Condenser fins are sharp; handle with care.

• Remove and clean condenser: Open the lower front flap and slide out the condenser (heat exchanger). Rinse thoroughly under running water to remove lint and dust. Allow it to drain and dry before reinstalling.
• Clean housing: Use a vacuum and soft brush to clean the condenser compartment and air channels. Remove any lint mats blocking airflow.
• Check condenser fan (if equipped): On heat pump models, access the fan behind the condenser. Ensure it spins freely and is not obstructed. Replace the fan motor if seized or noisy.
• Reinstall correctly: Make sure the condenser is fully seated and the access door closes tightly to prevent air leaks.
• Run a test cycle: After cleaning, run a full drying cycle and monitor for improved performance and absence of E11.