E20
Fagor
General System Error / Undefined Fault
Dryer shows E20; may not start or may stop with no other obvious symptoms.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Transient software glitch, Multiple sensor faults detected, Internal PCB error, Incorrect installation or wiring
How to Fix / Troubleshooting
Safety first: Unplug the dryer before any inspection.
- Perform a hard reset: Disconnect power for at least 10 minutes. Press and hold Start/Pause for 10 seconds (if applicable), then reconnect and test.
- Check installation: Verify that the dryer is connected to the correct voltage and that the exhaust or condenser system is installed according to the manual.
- Review other symptoms: Note any additional behavior (no heat, no rotation, unusual noises) and cross-check with other specific error codes or faults.
- Inspect PCB and wiring: Remove top and rear panels to visually inspect wiring harnesses and the main PCB for obvious damage or loose connectors.
- Service mode diagnostics: Some Fagor models allow entering a diagnostic mode to read sub-codes. This is typically for technicians; consult service documentation.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements