EAF
Frigidaire
Main control board failure or configuration error
Frigidaire dryer will not start and displays EAF on the control panel.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed main control board, Corrupted control software, Loose wiring harness to control board, Incorrect or damaged EEPROM on control board
How to Fix / Troubleshooting
Safety First: Unplug the dryer before accessing the control board.
- Power cycle:
- Disconnect power for 5–10 minutes, then restore power and attempt to start a cycle.
- Inspect control board connections:
- Remove the top panel and locate the main control board.
- Check all harness connectors for secure fit and signs of corrosion or heat damage.
- Reseat each connector one at a time.
- Check for visible board damage:
- Look for burnt components, cracked solder joints, or moisture damage.
- Replace control board:
- If EAF persists and wiring is intact, replace the main control board with the correct Frigidaire OEM part for your model.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements