Dryer display and controls work, but there is no heat; clothes come out cold.

Safety first: Unplug the dryer and allow it to cool before accessing the heater area.

• Confirm no heat: Run a high heat program for 10 minutes and check if the air inside is warm. If not, proceed.
• Access heater or heat pump: Remove the rear or side panel to reach the heater assembly or heat pump module.
• Test thermal fuse and thermostats: Use a multimeter to check continuity. Replace any open safety devices and investigate the cause of overheating.
• Check heater element: Measure resistance of the heater. Replace if open or shorted.
• Heat pump models: If the compressor does not start and E-codes are absent, check the compressor and inverter board connections. Heat pump diagnosis beyond basic checks should be done by a professional.