E16
Gaggenau
Door lock / safety interlock circuit fault
Dryer shows E16; drum light may work but the unit will not start.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective door lock switch, Broken door catch, Misaligned door, Faulty wiring between door lock and control
How to Fix / Troubleshooting
Safety first: Disconnect power before working on the door assembly.
- Check door alignment: Ensure the door closes evenly and the hinges are not sagging. Tighten hinge screws if needed.
- Inspect door catch and strike: Replace any cracked or worn parts that prevent a firm latch.
- Test door lock switch: Access the door lock assembly from the front panel. Use a multimeter to test the switch contacts while operating the lock. Replace the assembly if readings are inconsistent.
- Check harness: Follow the wiring from the door lock to the control board, looking for pinched or broken wires. Repair or replace as necessary.
- Control input: If the lock and wiring are good but E16 remains, the control board input circuit may be faulty and require replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements