E24
GE
Cycle Selector / Rotary Encoder Error
GE dryer shows E24 and may not start or may shut off when selecting certain cycles.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed cycle selector switch, Loose selector wiring harness, Worn encoder contacts, Faulty user interface board
How to Fix / Troubleshooting
Safety first: Disconnect power before removing the control panel.
Inspect cycle selector:
- Remove the control console screws and tilt the panel forward.
- Locate the cycle selector knob and its attached switch or encoder.
- Ensure the knob is not cracked or slipping on the shaft; replace the knob if loose.
- Check the wiring harness for secure connections and no corrosion.
- If accessible, rotate the selector through all positions while observing for smooth operation.
- If the selector is intermittent or physically damaged, replace the cycle selector switch or UI board assembly (depending on design).
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Cycle Selector Switch
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements