Grundig Worn Drum Support Components

Dryer is running but makes a loud squealing or screeching noise during drum rotation

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Worn drum support rollers, Dry or worn idler pulley, Worn drum rear bearing, Foreign object trapped between drum and cabinet

How to Fix / Troubleshooting

Safety first: Disconnect the dryer from mains before removing panels or reaching inside the cabinet.

  • Isolate the noise: Run the dryer briefly (with panels on) to identify whether the noise comes from the front, rear, or bottom. Then unplug and proceed.
  • Inspect drum edges: Check the gap between the drum and front panel for trapped objects (coins, bra wires). Remove any debris.
  • Check rollers and idler: Remove the front and/or rear panels to access drum support rollers and idler pulley. Spin each by hand; replace any that squeal, wobble, or feel rough.
  • Lubrication: Do not oil sealed bearings. Only use manufacturer-approved lubricant on specified points if recommended; otherwise replace worn parts.
  • Reassemble and test: After replacing components, reassemble and run a test cycle to confirm the noise is gone.
Advertisements

Repair Difficulty

Medium 3/5

Required Part

Drum Support Rollers
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements