Hoover
Display / Indicator Failure
Dryer display is blank but drum runs when the door is closed and start is pressed (basic models)
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blown display PCB, Failed LEDs or display module, Loose connector to display, Faulty low-voltage supply on PCB
How to Fix / Troubleshooting
Safety first: Unplug the dryer before removing the control panel.
- Check if machine operates: If cycles run normally but the display is blank, the issue is likely limited to the display or indicator circuit.
- Inspect connectors: Remove the control panel and reseat the connectors to the display board.
- Replace display PCB: If connections are sound and there is still no display, replace the display module or UI PCB as a unit.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements