E16
Hoover Software / Program Selector Fault

Dryer shows E16 and may not respond to commands

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Faulty rotary selector switch, Broken selector knob shaft, Dirty or worn selector contacts, Control board reading error

How to Fix / Troubleshooting

Safety first: Disconnect mains power before removing the control panel.

  • Check selector knob: Ensure the knob is not cracked or slipping on the shaft. Replace if loose.
  • Clean selector contacts: Remove the control panel and access the rotary switch. If accessible, clean contacts with electrical contact cleaner. Do not use excessive liquid.
  • Inspect for mechanical damage: If the selector does not click positively into positions, the switch may be worn and require replacement.
  • PCB diagnosis: If a new selector does not resolve E16, the control PCB may be misreading the selector and need replacement.
Advertisements

Repair Difficulty

Medium 3/5

Required Part

Program Selector Switch
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements