Hotpoint-Ariston
Worn Drum Rear Bearing or Front Felt Seal
Dryer makes a low rumbling or grinding noise, especially at high loads.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Worn rear drum bearing, Worn front felt seal allowing metal-to-metal contact, Drum shaft wear, Foreign objects caught in front seal
How to Fix / Troubleshooting
Safety first: Disconnect mains power before removing panels.
- Check for foreign objects: Look inside the drum for coins, buttons, or other items stuck in the drum holes or front gap. Remove any debris.
- Inspect front seal: Remove the front panel and examine the felt seal around the drum opening. Replace if worn through, torn, or contaminated with melted fibres.
- Check rear bearing: Access the rear of the drum. Wiggle the drum up and down; excessive play or grinding indicates a worn rear bearing. Replace the rear bearing kit and lubricate as specified.
- Reassemble and test: After replacing worn parts, run a test cycle with a small load to confirm noise reduction.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Drum Rear Bearing / Front Felt Seal
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements