Dryer does not detect moisture correctly, may stop too early with clothes still wet, F30 displayed.

Safety first: Unplug the dryer before cleaning internal components.

• Clean sensor bars: Inside the drum, locate the two metal moisture sensor strips (usually near the lint filter opening). Clean them thoroughly with a soft cloth and a bit of white vinegar or mild detergent to remove fabric softener residue.
• Check wiring: Access the back of the sensor bars from behind the front panel. Ensure the wires are securely attached and not broken.
• Inspect for damage: Replace the sensor bars if they are physically damaged or heavily corroded.
• Test in timed mode: Run a timed (non-sensor) cycle. If the dryer works normally, the issue is likely limited to the moisture sensing circuit.