Hotpoint
Door Interlock Stuck Closed
Dryer door will not open at end of cycle (where door lock is fitted)
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty door lock mechanism, Swollen or misaligned door catch, Control board not releasing lock, Wiring fault to door lock
How to Fix / Troubleshooting
Safety first: Switch off and unplug the dryer before attempting to force the door.
Steps to check:
- Wait a few minutes: Some models delay door release briefly after cycle end. Wait 2–5 minutes and try again.
- Manual release: On some Hotpoint dryers, a manual release tab is accessible by removing the top cover and reaching down to the door lock. Pull gently to release.
- Inspect lock: Once open, remove the front panel or lock screws and inspect the door lock for heat damage or mechanical failure. Replace if faulty.
- Check door catch: Ensure the door catch is not bent or swollen and engages smoothly.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements