Dryer takes too long to dry or never fully dries clothes, but appears to heat normally

Safety first: Unplug the dryer before removing panels or ducts. Wear a dust mask if sensitive to lint.

• Clean lint filter thoroughly: Remove and clean the filter after every load. If coated with residue, wash with warm soapy water, rinse, and dry completely.
• Clean condenser/heat exchanger: On condenser and heat pump models, remove the condenser from the lower front compartment and rinse under running water until clear. Let it drain before reinstalling.
• Inspect vent system (vented models): Disconnect the vent hose and check for lint clogs or crushed sections. Clean the entire run to the outside vent hood.
• Clean internal ducts: Remove rear or side panels and vacuum lint from blower housing and ducts. Take care not to damage sensors or wiring.

After restoring airflow, run a test load. If drying is still poor, check the moisture sensor bars for contamination and clean them as described in other entries.