E10
Ikea Configuration / Program Parameter Error

Dryer shows E10, often related to sensor or configuration issues, may not start certain programs

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Incorrect configuration of control board, Faulty program selector or user interface, Internal memory error, Incompatible replacement control board

How to Fix / Troubleshooting

Safety first: Disconnect power before accessing control components.

  • Power cycle: Unplug the dryer for 5–10 minutes and reconnect. Attempt to start a basic timed cycle.
  • Try different programs: If only specific programs trigger E10, the program selector or its contacts may be worn or dirty. Rotate the selector through all positions several times to clean contacts.
  • Check user interface connections: Remove the control panel fascia and reseat the ribbon cable or harness between the user interface and main control board.

If E10 continues, the control board may need to be reconfigured or replaced with the correct model-specific board. This typically requires service documentation and may be best handled by a technician.

Advertisements

Repair Difficulty

Hard 4/5

Required Part

User Interface Control Board
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements