F26
JennAir
Motor Drive System Error
Dryer displays F26 and may not start or may stop unexpectedly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed drive motor, Loose or disconnected motor harness, Faulty motor relay on control board, Seized blower wheel or drum causing overload
How to Fix / Troubleshooting
Safety first: Unplug the dryer before accessing the motor or internal components.
- Check drum movement: Open the door and try to rotate the drum by hand. It should turn smoothly. If it is very hard to turn, there may be a seized bearing, roller, or blower obstruction.
- Access the motor: Remove the front or rear panel (model dependent) to reach the drive motor and blower housing.
- Inspect wiring: Ensure the motor harness connector is fully seated and wires are not burned or broken.
- Check for obstructions: Inspect the blower wheel for lint clogs, foreign objects, or damage that could lock the motor. Clear any obstructions.
- Test the motor: With the belt removed, spin the motor shaft by hand; it should turn freely. If it is stiff or noisy, replace the motor. If the motor hums but will not start when powered, it is likely failed and needs replacement.
- Replace motor if necessary: Remove the belt, disconnect wiring, unbolt the motor, and install the new motor. Reinstall the belt, reassemble the dryer, restore power, and test.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements