Dryer runs for only a few minutes then ends the cycle with clothes still wet (no error code)

Safety first: Unplug the dryer before accessing internal wiring. Cleaning the sensor bars can be done with power off and door open.

• Clean moisture sensor bars: Wipe the metal sensor strips inside the drum with a cloth dampened with white vinegar or mild detergent to remove any residue.
• Use appropriate load size: Very small loads may not make good contact with the sensors. Add a few similar items to increase load size.
• Try timed dry: If sensor cycles end too soon, use a timed program as a workaround until the sensor circuit is repaired.
• Inspect sensor wiring: If comfortable, remove the front panel and check the wiring from the sensor bars to the control board for damage.