E14
Logik
Internal Communication / EEPROM Fault
Dryer shows E14; unit may not start or may stop unexpectedly; internal temperature seems normal
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware on main control PCB, Faulty memory (EEPROM) chip, Voltage spikes causing logic errors, Poor connection between control boards
How to Fix / Troubleshooting
Safety first: Disconnect power before accessing control boards.
- Power reset: Unplug the dryer for at least 10 minutes to allow capacitors to discharge. Reconnect and try to start a basic timed cycle.
- Check board connections: Remove the top cover and inspect all connectors on the main control PCB and any auxiliary boards. Reseat each connector firmly.
- Inspect for damage: Look for burnt components, cracked solder joints, or water damage on the PCB. If present, the board will likely need replacement.
- Firmware update (if available): Some Logik models may support firmware updates via service tools; this is typically done by authorized service centers.
- Board replacement: If E14 persists after resets and connector checks, the main control PCB should be replaced with the exact part number specified for your model.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements