F72
Maytag
User Interface Mismatch or Configuration Error
Dryer displays F72 and may not start or may behave erratically.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect replacement UI installed, UI not configured for model, Corrupted control software, Faulty main control board
How to Fix / Troubleshooting
Safety First: Unplug the dryer before accessing the console.
- Step 1 – Confirm part numbers: Verify that any recently replaced user interface or main control board matches the exact Maytag part number specified for your model.
- Step 2 – Check connectors: Ensure all UI connectors are fully seated and in the correct positions as per the wiring diagram.
- Step 3 – Perform configuration (if applicable): Some replacement boards require entering a model code or running a configuration routine. Refer to the tech sheet stored inside the dryer cabinet for the correct procedure.
- Step 4 – Replace incorrect parts: If the wrong UI or control board was installed, replace it with the correct OEM part.
- Step 5 – Test operation: After configuration and reassembly, restore power and verify that the dryer operates without F72.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
User Interface Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements