F74
Maytag
Control Calibration or Software Error
Dryer displays F74 and may not respond to commands.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control firmware, Power surge, Incomplete control initialization, Failed main control board
How to Fix / Troubleshooting
Safety First: Unplug the dryer before accessing internal components.
- Step 1 – Hard reset: Disconnect power for at least 10 minutes to fully discharge the control. Plug back in and attempt to start a cycle.
- Step 2 – Check for stuck keys: Ensure no buttons are physically stuck on the console, as this can interfere with initialization.
- Step 3 – Inspect control board: Access the main control and look for visible damage such as burned components or corrosion.
- Step 4 – Replace main control: If F74 persists after reset and there is no external cause, replace the main control board with the correct OEM Maytag part.
- Step 5 – Verify operation: Reassemble, restore power, and run multiple cycles to confirm stable operation.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements