Dryer shows E16 and may not start or may stop with beeping

Safety first: Disconnect power before removing internal covers. Water and electricity are a hazardous combination.

E16 is specific to condensing/heat pump dryers with a water tank.

• Empty the water tank: Pull out the condensate tank and empty it completely. Reinsert it firmly until it clicks into place.
• Clean the tank and float: Rinse the tank and ensure the float moves freely. Remove any lint or residue that could jam the float.
• Check drain path: Inspect the internal drain hose from the condenser to the tank for kinks or blockages. Clean if necessary.
• Test float switch: If accessible, test the float switch for proper operation with a multimeter. Replace if stuck or electrically open/shorted.

If E16 persists with an empty, correctly seated tank, the level sensor or control board may be faulty and require service.