Dryer runs for only a few minutes then ends the cycle with clothes still wet, no error code shown.

Safety first: Disconnect power before cleaning sensor contacts.

• Clean sensor bars: Locate the metal strips inside the drum (usually near the filter) and clean thoroughly with white vinegar or a non-abrasive cleaner to remove residue.
• Use larger mixed loads: Very small loads may not make consistent contact with the sensors. Add a few clean towels to improve sensing.
• Try timed program: Run a timed drying cycle. If this works normally, the issue is likely with the moisture sensing system.
• Inspect wiring: If accessible, check the sensor wiring harness for loose connections and repair as needed.