Montpellier Thermal Overload Trip

Dryer stops mid-cycle and all lights go off, then comes back on after cooling.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Blocked airflow, Overloaded drum, Failing motor overheating

Safety first: Unplug the dryer and allow it to cool fully before inspection.

Reduce load size: Dry smaller loads to reduce strain on the motor and heater.
Clean filters and ducts: Ensure lint filter, condenser, and venting are completely clear.
Check motor ventilation: Remove rear panel and vacuum dust from around the motor and fan housing.
Test again: Run a short cycle. If the dryer still cuts out, the motor or thermal cut-out may be failing and should be tested and replaced if necessary.

Medium 3/5

Motor Thermal Cut-Out

Check Price on Amazon

We may earn a commission from links on this page.