E14
Montpellier
EEPROM / Program Memory Error
Dryer shows E14 and will not start; sometimes occurs after a power surge or outage.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware on main PCB, Failed memory IC, Voltage spike damage to control board
How to Fix / Troubleshooting
Safety first: Disconnect the dryer from mains before accessing electronics.
- Power reset: Unplug the dryer for at least 15 minutes to allow capacitors to discharge, then reconnect and try again.
- Check supply quality: Ensure the dryer is connected to a stable mains outlet, not an overloaded extension lead.
- Factory reset (if available): Consult the Montpellier user manual for any key combination to reset the control. Perform the reset if documented.
- Professional reprogramming: If E14 persists, the main PCB may require firmware re-flashing or replacement by an authorised Montpellier service centre.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements