E16
SMEG
EEPROM / Configuration Data Fault
Dryer shows E16; may not respond to program selection or Start button.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware on main control board, Failed memory (EEPROM) chip, Interrupted power during software update (if applicable), Control board hardware failure
How to Fix / Troubleshooting
Safety first: Unplug the dryer before accessing the control electronics.
- Power cycle: Disconnect the dryer from mains for at least 10 minutes to allow a full reset. Reconnect and test.
- Check for service mode: Some SMEG models allow entering a diagnostic mode to reset configuration. Refer to the service manual; do not change undocumented parameters without guidance.
- Inspect control board: Remove the control panel and visually inspect the main PCB for damage. If no physical damage is visible, the EEPROM may still be corrupted.
- Replace control board: In most domestic repair scenarios, the main control board is replaced as a unit when EEPROM faults occur. Transfer connectors carefully and secure the new board.
- Professional reprogramming: If the new board requires configuration for your specific model, this may need to be done by an authorized SMEG service technician with the correct tools.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements