Dryer shows E09 and will not start or stops unexpectedly, sometimes with no drum movement
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Unplug the dryer before removing the front panel or door components.
Step-by-step checks:
- Inspect door hardware: Check the door strike and latch for cracks, wear, or misalignment. Adjust hinges if the door is sagging and not closing squarely.
- Test door lock switch: Access the door lock assembly from inside the front panel. Disconnect the harness and test the switch contacts with a multimeter while operating the latch. Replace the assembly if continuity does not change as expected.
- Check harness: Follow the wiring from the door lock to the control board. Look for pinched, cut, or burnt wires. Repair or replace as needed.
- Control input: If the lock and wiring are good, the control board may not be reading the door-closed signal correctly and may require replacement.
When to call a technician: If the front panel is difficult to remove or if you suspect control board failure, professional service is recommended.
Repair Difficulty
Required Part
We may earn a commission from links on this page.