E08
Stoves
Control Board Communication / Internal Control Error
Dryer display shows E08 and unit will not start, often after a power surge or outage
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control board firmware, Failed main control board, Loose control harness connections, Power surge damage
How to Fix / Troubleshooting
Safety first: Disconnect power for at least 5 minutes before inspecting electronics.
- Perform a hard reset: Unplug the dryer or switch off the breaker for 5–10 minutes. Restore power and see if E08 clears.
- Check control connections: Remove the top panel to access the main control board. Inspect all harness connectors for secure fit and signs of heat damage or corrosion. Reseat each connector.
- Inspect the user interface board: If accessible, check the display/control panel board for moisture, corrosion, or burnt components.
- Surge protection: If E08 occurred after a storm or outage, consider using a surge protector once the dryer is repaired.
- If error persists: The main control board is likely faulty. Replacement usually requires transferring wiring one connector at a time to the new board. If you are not comfortable with electronic repairs, contact a qualified technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements