E10
Stoves
User Interface / Control Panel Fault
Dryer displays E10 and will not start, often accompanied by unresponsive buttons
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed touchpad or button board, Loose ribbon cable between UI and main board, Moisture intrusion into control panel, Cracked control fascia
How to Fix / Troubleshooting
Safety first: Unplug the dryer before removing the control panel.
- Check for lock mode: Ensure the control lock/child lock feature is not enabled. Refer to the user manual to disable it. If E10 remains, proceed.
- Inspect the control panel: Remove the screws securing the control console and gently pull it forward. Look for signs of moisture, corrosion, or physical damage.
- Reseat ribbon cables: Disconnect and reconnect the flat ribbon cable(s) between the user interface and main control board. Ensure they are fully inserted and latched.
- Dry out moisture: If there are signs of condensation or liquid spills, allow the panel to dry completely before reassembly. Do not use heat guns directly on electronics.
- Replace UI board if necessary: If specific buttons do not respond or E10 persists, the user interface board may need replacement. Transfer any overlays or knobs from the old panel to the new one.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
User Interface Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements