Dryer shows E19 and the buzzer or end-of-cycle signal does not work correctly

Safety first: Unplug the dryer before accessing the control console.

• Check sound settings: Ensure the end-of-cycle signal is enabled in the options menu. Some models allow muting the buzzer.
• Locate the buzzer: Inside the control console or near the control board, find the small buzzer or speaker component.
• Inspect wiring: Verify the buzzer connector is firmly attached and the wires are intact.
• Test buzzer: If you have a multimeter, check for continuity across the buzzer terminals. An open circuit indicates a failed buzzer that should be replaced.
• Control board check: If the buzzer is good but never receives voltage during the end-of-cycle, the control board output may be faulty and require replacement.