Display shows DOOR and cook cycle will not start or pauses

Safety first: Unplug the smoker before adjusting or replacing the door switch.

Steps:

• 1. Check door closure: Close the door firmly and ensure the latch fully engages. If the door feels loose or does not seal, adjust the latch or hinges according to the manual.
• 2. Locate the door switch: On many Cookshack models, the switch is near the door frame or behind a small cover. When the door closes, a tab or striker presses the switch.
• 3. Test the switch: With power disconnected, remove the switch and test continuity with a multimeter while pressing and releasing the actuator. Replace the switch if it does not change state reliably.
• 4. Adjust alignment: If the door does not fully depress the switch, gently bend the actuator or adjust the striker plate so the switch is fully engaged when the door is closed.
• 5. Inspect wiring: Check the switch wires for breaks or loose connectors and repair as needed.

Note: Never bypass the door switch permanently; it is a safety device.