Landmann
No Power / Dead Unit
Smoker does not power on at all; no lights or display when plugged in and power button pressed.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blown household circuit breaker, Faulty Landmann power cord, Failed internal fuse on control board, Loose or burnt connections at power inlet or terminal block
How to Fix / Troubleshooting
Safety first: Ensure the smoker is unplugged before opening any panels. Do not work on live circuits.
Steps to restore power:
- Check the outlet: Test the wall outlet with another appliance. Reset any tripped GFCI or breaker.
- Inspect the power cord: Look for cuts, frays, or melted areas. If damaged, replace the cord with the correct Landmann-rated cord.
- Access the terminal block: Remove the rear or bottom panel to locate where the power cord connects inside. Tighten any loose screws and inspect for burnt terminals. Replace the terminal block if damaged.
- Check internal fuse (if equipped): Some Landmann control boards have a small glass or ceramic fuse. Remove and test for continuity. Replace only with the same type and rating.
- Reassemble and test: After securing all connections and replacing any failed components, reassemble the smoker and test for power.
Note: If power still does not reach the control board, the board itself may have an open circuit and require replacement.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements