Smokehouse Products
Display Module Failure
Digital display is blank or very dim, but heating element still works when turned on by knob or switch.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed LED/LCD display, Loose display ribbon cable, Low-voltage regulator failure on control board
How to Fix / Troubleshooting
Safety first: Unplug the smoker before removing the control panel.
- Check contrast/brightness (if available): Some models have a small adjustment for display brightness; verify it is not turned down.
- Inspect display connector: Remove the control panel and reseat the ribbon cable or plug between the display and main board.
- Look for board damage: Check for burnt components near the low-voltage regulator section of the PCB.
- Replace display or control panel: If the display remains blank, replace the display module or entire control panel assembly as supplied by Smokehouse Products.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Display Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements