E9
Smokin Tex Internal Memory or Calibration Error

Display shows E9; smoker may power on but cannot be set or will not maintain temperature.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Corrupted control board firmware, Loss of calibration data, Control board component failure, Voltage spike damage

How to Fix / Troubleshooting

Safety: Unplug the smoker before any disassembly.

Reset attempts:

  • Unplug the smoker for at least 5 minutes to allow the control to fully discharge, then plug back in and try again.
  • If your Smokin Tex model supports a factory reset (refer to the user manual), perform the reset sequence to clear stored errors.

If E9 remains:

  • The control board's memory or calibration is likely damaged. There is no field repair for this; the board must be replaced.
  • Order the correct control board using the smoker's model and serial number. Transfer all connectors carefully from the old board to the new one.

Note: After replacing the board, verify temperature accuracy with an oven thermometer during the first few cooks.

Advertisements

Repair Difficulty

Medium 3/5

Required Part

Electronic Control Board
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements