ABL charger shows E12; charging is disabled and the unit may indicate a configuration or DIP switch error.

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Incorrect DIP switch settings for current or phase mode, Corrupted configuration in ABL controller firmware, Incompatible parameter set after firmware update, Faulty non‑volatile memory on main control board

How to Fix / Troubleshooting

Steps:

Check DIP switches: Open the charger (power OFF) and compare the DIP switch positions with the ABL installation manual for your model and supply type.
Reset to defaults: If supported, perform a configuration reset via the ABL app or web interface, then re‑enter the correct settings.
Firmware alignment: Ensure that the firmware version is compatible with your hardware revision. Only use official ABL firmware.

If E12 remains: The configuration memory on the main control board may be defective. Board replacement by an authorized technician is recommended.

Repair Difficulty

Medium 3/5

Required Part

ABL main control board

Check Price on Amazon

We may earn a commission from links on this page.