STATUS FLASH 9
ClipperCreek
Memory / Configuration Error
STATUS LED flashing 9 times repeatedly (9-blink pattern), EVSE does not operate.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted configuration memory on control board, Incorrect dip switch or current setting, Failed EEPROM or NVRAM, Incompatible replacement board installed
How to Fix / Troubleshooting
Safety first: Turn OFF power at the breaker before opening the EVSE enclosure.
- Check current setting: On some ClipperCreek models, maximum output current is set via internal dip switches or jumpers. Verify they match the unit rating and installation manual.
- Inspect for non-OEM parts: If the board was recently replaced, confirm it is the correct ClipperCreek part number for your model.
- Reset configuration (if supported): Some models allow a factory reset via a specific power-up sequence or jumper. Refer to the service documentation; perform only if documented.
- Power cycle: Turn OFF the breaker for several minutes, then ON, to see if the error clears.
If configuration or memory cannot be restored and the 9-blink pattern persists, the control board must be replaced with the correct OEM board.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements